Out of stock. We'll send one email when this is back. No countdown timers, no spam.
Your placard has buckles and a hook back. Your carrier has PALS or a laser cut front and nothing for either one to grab. The SwiftClip Conversion Kit gives it both.
Two 1″ female QASM buckles ride on webbing at the top and a loop field is sewn to a rigid platform below them. The buckles carry the weight and the platform keeps the loop flat, so the placard’s hook lands on a solid face and stays put through running and prone instead of lifting at the bottom or sliding when you draw a mag.
It weaves through the PALS or laser channels with no cutting or sewing. Any placard with 1″ male SwiftClip buckles and a hook back then goes on and off in seconds.
Regular is 6.5 by 4 in. over four columns for a standard front.
Large is 9.5 by 6 in. over six columns for wide fronts and bigger rigs.
Need conversion only for your placard? See the Front Placard Conversion Panel.
Handmade in Knoxville, TN.
Regular: 6.5 in. x 4 in., covers 4 MOLLE columns
Large: 9.5 in. x 6 in., covers 6 MOLLE columns
Buckles: 1 in. female QASM (SwiftClip)
2x 1" Female QASM buckles with webbing
Loop field sewn to a rigid Curve platform
Mounts to PALS/MOLLE webbing or laser cut fronts with no modification to the carrier
Compatible with any placard or chest rig using 1" Male side release buckles and a hook backing
Colors: Black, Coyote, Ranger Green
Berry Compliant
Handmade in Knoxville, TN
